Audio Equipment

An antique pulled from a tube radio set, with B+ and -C terminals.

JBL UREI 7922 Audio Delay unit. Very good condition. Please read full description.

JBL model 5195 plug in transformer, used, fair condition.

A pair of 10 inch coaxial drivers, removed from Akai model SS-1210 cabinets. VG condition, tested, working, priced per pair.

These Baluns are used in pairs to transmit S-Video & Stereo Audio over CATx Ethernet cable. Priced per PAIR!

An HP 9100-1913 Power Transformer, 66B-86MS TF4RX01YY. NOS.

Vintage 70s QUADROPHONIC headphones,Excellent condition.

A 2 Channel unit perfect for making up for up to 10 Seconds of Video Delay due to DSP Latency in switchers, servers and Web Streaming setups. Very Good condition.

NOS drives from HP. Sealed in the original packing, untested and sold As Is. One has been unpacked for the photographs.

The Matchbox by Henry Engineering. IHF to Pro Interface -10db to +4db. Stereo XLR input and outputs, to RCA inputs and outputs.

An inexpensive boom arm for Broadcast desks or vocal booths. In good condition.

A 50s era mono amplifier from the estate of a local RCA engineer. Being sold without tubes, all original construction. Untested, as is.

An early backup drive from a DAW setup. It runs, but we're unable to test it due to a lack of any cartridges. Sold with cable and SCSI terminator.

16 Channel 55' Gepco snake, fanned, one end prepped blunt, to 8 XLRs.

20 Channel 12' Gepco snake, fanned, 1/4" TRS to TRS & RCA connectors

Gepco's Oxygen Free Copper & Nickel plated connectors resist oxidation and ensure signal integrity. Standard plastic barrel. Priced Per Cable

Gepco 16 Channel 32' Snake, fanned, Mixed XLR & 1/4" on both ends

12 Channel, 14', Fanned, Mixed 1/4" TRS & 1/4" TS both ends

A vintage General Electric Brightness meter with leather case and plug-in sensor. Very good condition.

Provides +4 dbm, Balanced outputs for your consumer level sources. Very quiet, lo THD with 10 turn pots for each output. Great for studios using Legacy Tape, VTR, or Tascam 8 Track Reel to Reel tape decks.

A potted transformer for preamp circuits, with Mu Metal shielding. Excellent condition. Sealed, with keyed octal plug.

A 2 RU Sequential Rack power switcher and 24VDC power supply.

A subsystem of the the 4010, this is a VITC Reader and Window burn generator. Requires 4010 for operation.

This interface allows Edit control over Otari Reel decks using the Fostex 4030/4035 Editing system. It has a 34 Pin cable attached that connects to Otari's Locator Port.

For any setup requiring VTR or ATR Chase of another deck, the Fostex system provides solid sync between formats using a number of sources. The 4035 provides Edit control functions over various Fostex devices.

For any setup requiring VTR or ATR Chase of another deck, the Fostex system provides solid sync between formats using a number of sources. Sold AS IS, all sales are final.

Perfect for Stereo SubMixes of Keys or any other Line sources, Live or in the Studio. Very Clean.

Audio input transformer, Mu-Metal Shielded case, Manufacturer Unknown. From Bud Pressner's Gary IN studios. See Photo #4 for windings and Ω information.

Eight inch 2 way coaxial drivers with treated surrounds and a center mounted Piezo tweeters.

Executone Mixer amplifiers, 3 inputs: mic/aux/tel, rack or wall mount, 60/100 watt, 70V/8 ohm, Excellent condition

Electro Voice EVM12L Pro driver, This is the original version that has been replaced by the "classic" and Zakk Wylde Black Label versions. Hard to find. *Please note the price is for a single speaker.*

Woofer, Tweeter, Crossover and baffle for an EV Sentry I Broadcast monitor. No cabinet is included.

EV 649 Dynamic Lavalier microphone, necklace style, working condition, with neck loops & balanced XLR mic cables.

An Uncommon model from Epicure, famous for their introduction of the 'Air Spring' tweeter. Fair cosmetic condition, they perform flawlessly and sound wonderful.

EMU Proteus 1 sound module, good condition. 16 Bit multi-timbral digital sound module

Electret Mike Philmore CM-55 bantam-sized microphone with flat frequency response high fidelity sound reproduction.

Removed from a MagnaTech 2000 series dubber setup, this meter has been tested and has a working movement. All Sales are final!

Digitech Studio Quad V2 4x4 Multi Effects Processor (cat=effects) untested, missing power supply

This is an 6x8 Midi Router and processor. A favorite of anyone who has ever owned one. Great for Live use.

10x10 Channel Digidesign Midi I/O Interface

Digidesign digital interface for 24-bit recording, editing, AD and DA signal conversion.

A Denon AV receiver with Phono inputs, in Very Good condition, no remote.

DBX II Model 142 Broadcast Noise Reduction System, balanced I/O. Stereo, 2 RU, Encode/Decode/Bypass for tape, disc. Cinch Jones I/O connector, Very Good condition.

dbx 900A series frame with 6 903 limiters, 2 905 EQ modules, 1 904 Noise gate and power supply. Sold as is, please read full description.

Good condition. Separate detector input enables an outboard processor to control compression or gating. Stereo or dual-mono operation of gating and compression, with hardwire bypass for each channel.

DBX165 Mono compressor/limiters sn 1300,1698. VVG cosmetics, Bal Input, Classic, great sounding compressor. Pictured is sn 1698, sn1300 photos to be posted soon. SOLD OUT.

dbx 160X Limiter, Fair Condition, With TRS & terminal strip I/Os. Earlier version manufactured in Japan.

dbx 158 rack frame with 9 dbx 410 Noise reduction cards.

DBX 157 stereo encode/decode, works with stereo recorders or dbx encoded discs. dbx is an excellent noise reduction system.

DBX150 typeI Noise Reduction -10db encoder/decoder, in VG condition. Front panel record and Playback level controls.